SFC-VTEC Main Menu

SFC-VTEC Wiring for H3 Cars

 

Compatible Cars (H3) Chassis Type Engine Name Year Model ECU Location
Integra (AT) DC2, DB8 B18C 6/93 ~ Left foot area of Passenger-side seat

Instructions:
 

  1. Turn off the Engine, and remove the (-) negative ground from your battery
  2. Remove all covers, etc., and locate your ECU
  3. Following the diagram below, wire your unit accordingly.
    • Use pliers to securely fasten the electrotaps.
    • Use proper crimping tools to fasten the terminals securely.
    • If you see wire that originally had a ring-shaped connector, please make sure that it gets properly grounded.
    • On some models, there will be wires that are not used, or left disconnected.  Please use electrical tape to terminate properly.
  5. Once the wiring is complete, set the dipswitches to the following configuration, and install the unit in your desired location.
  6. Re-connect your battery terminal, and confirm operation of the device.