| SFC-VTEC Main MenuSFC-VTEC Wiring for M2 Cars Compatible Cars (M2) | Chassis Type | Engine Name | Year Model | ECU Location | Mirage | CK4A | 4G92 | 10/95 ~ | Left foot area of Passenger-side seat | Cyborg | CJ4A | 4G92 | 10/95 ~ | Left foot area of Passenger-side seat | Asti | CJ4A | 4G92 | 1/96 ~ | Left foot area of Passenger-side seat | Lancer | CK4A | 4G92 | 10/95 ~ | Left foot area of Passenger-side seat | Aeterna | E54A | 6A12 | 10/93 ~ | Rear of Center Console | Emeraude | E54A | 6A12 | 10/94 ~ | Rear of Center Console | Galant | E54A | 6A12 | 10/93 ~ | Rear of Center Console | Diamante | F36A | 6G72 | 1/95 ~ | Rear of Center Console | FTO | DE3A | 6A12 | 10/94 ~ | Left foot area of Passenger-side seat | Instructions: - Turn off the Engine, and remove the (-) negative ground from your battery
- Remove all covers, etc., and locate your ECU
- Following the diagram below, wire your unit accordingly.
- Use pliers to securely fasten the electrotaps.
- Use proper crimping tools to fasten the terminals securely.
- If you see wire that originally had a ring-shaped connector, please make sure that it gets properly grounded.
- On some models, there will be wires that are not used, or left disconnected. Please use electrical tape to terminate properly.
- Once the wiring is complete, set the dipswitches to the configuration that matches your engine, and install the unit in your desired location.
- Re-connect your battery terminal, and confirm operation of the device.
|